Here is a closer look at the body work in the heater area. I saved the insulation from the green car to install. I found the plastic pins that you need to use at "The Paddock". They are not cheap and they are hard to insert without bending. I long Phillips machine screw and ground the end down to make an inserting tool. I treaded into the hole in the pin and I could tap on the end of the screw and the pin would have pressure on the pointy end instead of the flat head of the pin. It worked pretty good.

Close this window to return to the thumbnail photos or -

Click Here to go to the next page!

Last updated 5/10/2001